How to Refinish Hardwood Floors in 4 Easy Steps

Hardwood floors are a popular choice, because they are easy to maintain and beautiful to look at. Unfortunately, they can collect unsightly scratch marks over time. It’s not necessary to sand them down to the bare wood to make them look as good as new. Hardwood flooring refinishing in Kennesaw, GA, can be done in 4 easy steps.


Clean

For the first step, you need to empty the room of furniture and give it a good sweeping. Next, you’ll want to mop it using a hardwood floor cleaner or a 10:1 solution of water and vinegar. You should close all doors and windows to keep the dust that will be generated in the next step away from the rest of your house.


Sand and Buffer

For the second step, you’ll need to hand-sand the perimeter of the room with 180-grit sandpaper. You’ll also want to sand any areas the buffer can’t reach. You’re done when the finish looks dull and you can see a white powder forming. Next, it’s time to put on a dust mask and use a buffer to tackle the rest of the room. You’ll want to move in the direction of the grain and overlap each row just like you do when you vacuum or paint.


Vacuum

Take a 10-minute coffee break to let the dust settle. Then you can vacuum up the powder, but make sure to use a felt-bottom attachment to avoid damaging the floor. Before you move on to the next step, you’ll want to dry the floor using a microfiber cloth.


Apply the Finish

A respirator is a requirement for this step, and you should also wear booties to protect the flooring. Use a brush to apply the finish in a 3-inch wide strip beside the baseboard. You’ll have to work quickly to avoid lap marks. For the final step, you’ll roll out the finish across the floor, always overlapping each pass a little. You always want to keep a wet edge just as if you were painting. You can add a second coat 3 hours later if necessary, but you must wait for at least a week before putting furniture back into the room.